LORTONE Single Barrel Tumbler 3A
Product no.: 4825.3
Description
LORTONE Single-Barrel Tumbler 3A
Perfect rock tumbler for those just getting started.
Our all rubber barrels are quiet and long wearing. The single 3 lb. capacity barrel is sized for smaller stones up to 1-1/4 inches. We've molded the barrel with special ribs to increase the tumbling action. Base dimensions: 6"W x 9.5"L.
Barrel inside dimensions: 4-1/8" depth, 3-7/8" diameter.
Features
- Simultaneous editing of several parts possible, thus saving a lot of time.
- Rust and oxidation are removed very gently when using special ceramics.
- When using stainless steel polishing bodies creates the finest high gloss. The surface is additionally compacted.
- Also suitable for structured surfaces.
Application
The polishing drum from Lortone has already been tried and tested in the polishing and grinding of gold, silver (silver chains), metal, aluminum, tin, plastic, etc. (if you have a special material contact us, we will be happy to advise you! )
Technical specifications
- Drum dimensions outside Ø (WxH) -> 114 x 135 mm
- Drum dimensions inside Ø (WxH) -> 102 x 100 mm
- Drum contents -> 0.80 l
- Power -> 73 W
- Revolutions per minute -> 24
- Frequency -> 50 Hz
- Voltage -> 220/230V, 65W (Unit is also suitable for UK/Australia with the appropriate plug; for the USA an appropriate plug with voltage converter is required)
- Dimensions of the device (WxHxD) -> 240 x 150 x 140 mm
- Weight (kg) -> approx. 2.00
Delivery
- LORTONE polishing machine 3A with a polishing drum
Application
- For a ceramic filling for fine grinding about 0.5 kg ceramic parts are needed. For a steel filling for polishing about 1.0 kg steel parts are needed.
Stones Grinding And Polishing
- For grinding and polishing stones, we recommend our Silicium Carbide Set
Maintenance of the polishing drum
Make sure that the outside of the drum is always clean and dry before it is placed on the shaft. A new drum may initially show slight rubber abrasion on the shafts. This is normal. Then clean the drum with a dry cloth and possibly also the shafts with a little white spirit. If the drum has been running for a long time, it is possible that the surface is no longer as grippy and that it slips a little on the waves. Then lightly roughen the outside of the rubber drum with a fine brass wire brush.
Shafts and sleeve bearings should always be kept clean (free of dust and dirt accumulation), especially at the end of the shaft, to prevent contamination of the sleeve bearings. If a shaft does not turn well after a long period of use or if the shaft squeaks, you should use a drop of oil on the end of the shaft. The oil gets into the bearing as a result of the rotary movement.
Continuous operation
The motor is intended for continuous operation. It can and should run continuously day and night. It is normal for it to get hot and the case to get warm as a result.